Panasonic DMC-LZ5 Digital Camera User Manual


 
Others
92
VQT0U87
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
An error has occurred accessing the card.
Insert the card again.
A card with a capacity more than 2 GB is
inserted. Do not use a card with a
capacity more than 2 GB.
[READ ERROR
PLEASE CHECK THE CARD]
An error has occurred reading the data.
Insert the card again. Make sure the card is
inserted properly and then play back again.
[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card.
Insert the card again and turn the camera
on. Make sure the camera is turned off
before removing or inserting the card to
avoid damage.
[MOTION RECORDING WAS
CANCELLED DUE TO THE LIMITATION
OF THE WRITING SPEED OF THE
CARD]
We recommend using a high speed SD
Memory Card with “10MB/s” or greater
displayed on the package when you set
the picture quality to [30fpsVGA].
Depending on the type of SD Memory
Card, recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there
are no remaining folder numbers that can
be used. (P81)
Format the card after saving necessary
data on a PC etc. (P78)
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P23)
Batteries and the power source
1: The camera turns off immediately
even when battery power is full.
The remaining battery power is low
even if new batteries are inserted.
The remaining battery power may not
be displayed accurately, and the
camera may suddenly stop working,
when the type of battery and the
settings on [BATTERY TYPE] are not
identical. However this is not a
malfunction. Depending on the battery
brand and the operating temperature, or
if exhausted batteries are used, the
remaining battery power may not be
displayed accurately.
– Please check [BATTERY TYPE] (P21)
in the [SETUP] menu.
2: The camera cannot be operated even
when it is turned on.
Are the batteries inserted correctly?
Use sufficiently charged batteries when
using Ni-MH batteries.
3: The LCD monitor turns off while the
camera is turned on.
Is power save mode (P22) or economy
mode (P22) activated?
Press the shutter button halfway to
cancel these modes.
Are the batteries exhausted?
Replace them with batteries which
have sufficient capacity. (When you
use Ni-MH batteries, charge them.)
4: The camera turns off immediately
after it is turned on.
Are the batteries exhausted?
VQT0U87ENG.book 92 ページ 2005年12月27日 火曜日 午後7時12分