40
VQT1D97
Setup
Setting date and time
When the unit is turned on for the first
time, a message asking you to set the
date and time will appear.
≥ Select [YES] and press the cursor
button in the center. Perform steps 2
and 3 below to set the date and time.
If the screen shows the incorrect date
and time, then adjust it.
¬Rotate the mode dial to select
or .
1 Press the MENU button, then
select [BASIC] #
[CLOCK SET] # [YES] and
then press the cursor button
in the center.
2 Press the cursor button left or
right to select the item to be
set. Then, press the button up
or down to set the desired
value.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 12-hour system is used to
display the time.
3 Press the cursor button in the
center to enter the selection.
≥ The clock function starts at
[00] seconds when the cursor
button in the center is pressed.
≥ After pressing the MENU button to
finish the setting, check the date
and time display.
∫ Changing the date and time
display style
Press the MENU button, then select
[SETUP] # [DATE/TIME] # desired
display style and then press the
cursor button in the center.
[DATE] [D/T]
[OFF]
DEC.15.2007 DEC.15.2007 3:30 PM
VQT1D97(ENG).book 40 ページ 2007年3月20日 火曜日 午後5時33分