Filter
Top Products
90 LSQT1438 91LSQT1438
Others
3
Messages
This section explains the main messages appearing on the LCD monitor and
how to deal with them.
Message What to check
CANNOT RECORD.
Writing on the SD card failed.
NO DATA.
Neither motion pictures nor still pictures are recorded
on the SD card.
Data is recorded on the SD card, but if this message
appears, the card may be unstable.
Turn the unit off and turn back on.
THIS CARD CANNOT
RECORD IN VIDEO
MODE.
An 8 MB or 16 MB SD card cannot be used in video
recording mode.
CHECK CARD.
The SD card is not supported or cannot be recognised
by the unit.
CARD LOCKED.
The SD card is write-protected. (P.13)
CARD FULL.
The SD card cannot be recorded on because it is full
or the numbers of scenes or numbers of scenes for
the date has reached the maximum. Either delete
unnecessary scenes or insert a new card. (P.56)
SCENE NUMBER IS
FULL.
CANNOT RECORD.
THE NUMBER OF
PROGRAM IS FULL.
CARD DOOR OPENED.
Close the card/battery door.
ERROR OCCURRED.
RECORDING IS
STOPPED.
Use a Panasonic SD card or other SD card
applicable for motion picture recording. (P.12)
If this message appears when an applicable
card is used, it is recommended to format the
card. Formatting deletes all data on the SD card.
Therefore, save data on a computer or other device
before formatting the card.
●
●
EXIT THE MENU THEN
CHANGE TO MANUAL
MODE.
Functions that cannot be used simultaneously were
selected. (P.97)
CANCEL NIGHT VIEW
MODE.
Message What to check
PLEASE CONNECT AC
ADAPTOR
You tried connecting the unit to a computer without
connecting the AC adaptor.
ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN.
The unit detected an error. Eject the SD card and turn
off the unit and turn back on.
DISCONNECT USB
CABLE.
The unit is not properly connected to a computer or
printer.
Disconnect and reconnect the USB cable.
CANNOT OPERATE
WHILE USB
CONNECTED.
The unit cannot be turned off while it is connected to
a computer.
CARD ERROR HAS
OCCURRED.
TO REPAIR THE
CARD, PLEASE
CONNECT AC
ADAPTOR OR
CHANGE BATTERY.
The data on the SD card contains errors.
To repair the data, either use a battery of sufficient life
or connect the AC adaptor. Depending on the error, it
may take time to repair the data.
NOW REPAIRING
DATA.
DO NOT REMOVE
CARD.
The data has been repaired.
Depending on the situation, the data may not be
completely repaired.
If the unit is turned off without repairing data, data can
be repaired the next time that the unit is turned on.
If repairing fails, the data cannot be played back.
Format the SD card with this unit.
Do not repair SD cards recorded on other devices
on this unit.
●
●
●
●
CANNOT CHECK
CONNECTED DEVICE.
DISCONNECT THE
USB CABLE FROM
THIS UNIT.
A device that cannot be used with this unit is
connected to the unit.
CONDITION TOO
DARK, OR OPEN
LENS COVER.
Before recording, open the lens cover.
This message may appear if you try to record in an
extremely dark place
After the unit is turned on, the message is displayed
when the initial recording mode is established,
but it is not displayed when manual recording is
performed.
●
●
●