Filter
Top Products
Connection and recognition
130
LSQT1025
With a computer
Connection and recognition
After the driver and software applications are installed, the unit must be connected to the computer
and be correctly recognized by the computer.
≥ Connect after installing the driver and software applications.
≥ If the supplied CD-ROM is inserted in the computer, remove it. (If the [Setup Menu] is running,
wait until it finishes, then remove the CD-ROM.)
≥ If the recognition procedure is not accomplished properly, operation will not be possible after
connecting the unit to the computer.
≥ If the unit fails to operate normally, it may mean that you have not conducted the installation or
recognition procedure properly.
≥ Be sure to finalize DVD-RW (VR format), DVD-RW (Video format) and DVD-R on this unit,
before using them on the computer. Un-finalized discs will not be recognized by the
computer.
¬Connect this unit to the AC adaptor.
1 Insert a disc or card with recorded images in the unit, turn on the unit
and
then select the unit’s operation mode.
When using a disc: Select .
When using a card: Select .
2 (Only in card playback mode)
Press the MENU button, then select [ SETUP]
# [ USB FUNCTION] # [PC CONNECT] and
press the joystick.
≥ Press the MENU button to exit the menu screen.
3 Connect this unit and a computer.
This unit is automatically recognized by the computer.
≥ Do not use any other USB cables except the supplied
one. (Operation is not guaranteed with any other USB
cables.)
Connection and recognition procedures
A USB cable (supplied)
≥ Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
A
LSQT1025(ENG).book 130 ページ ２００６年２月４日 土曜日 午後６時１０分