Filter
Top Products
2. Move the CAMERA ID to the desired position by pressing / / / .
3. Press to fix the position of the CAMERA ID. The mode returns to the previous CAM-
ERA ID menu.
Notes:
• The CAMERA ID stops at the edges of the monitor screen.
• The CAMERA ID moves faster if any of / / / is kept pressed for a sec-
ond or more.
2. Light Control Setting (ALC/ELC)
You can select the light control mode according to the lens type.
ALC: If you use the auto iris lens, select this parameter.
ELC: If you use a fixed or manual iris lens, select this parameter.
1. Move the cursor to the ALC/ELC parameter.
2. Select ALC or ELC.
2-1. ALC Mode with SUPER-D2 ON
Super Dynamic2 Function (SUPER-D2)
The important object in a scene is usually placed in the center of the monitor’s screen. In
SUPER-D2 mode, more photometric weight is given to the center of the screen (where the
important object is located) than to the edge of the picture (where a bright backlight would
most likely be located). You can use the SUPER-D2 function if you select ALC. It eliminates
interference by strong background lighting which makes the camera picture dark, such as a
spotlight.
1. After selecting ALC, press to open
the ALC CONT menu.
2. Move the cursor to the SUPER-D2
parameter and select ON
3. If you want to adjust the video output
level, move the cursor to the "I" posi-
tion. Adjust to the desired level by
pressing or .
** ALC CONT **
BACK LIGHT COMP
SUPER-D2 OFF
MASK SET
LEVEL ...I.....
- +
RET END
↵
** ALC CONT **
BACK LIGHT COMP
SUPER-D2 ON
LEVEL ...I.....
- +
RET END
1. Camera Identification (CAMERA ID) Setting
You can use the camera identification (CAMERA ID) to assign a name to the camera. The
camera ID consists of up to 16 alphanumeric characters. The camera ID display can be
switched on or off on the monitor screen.
To edit the CAMERA ID
1. Move the cursor to the CAMERA ID parameter.
2. Press . The CAMERA ID menu appears. The cursor on the letter “0” is highlighted.
3. Move the cursor to the character you
want to edit by pressing / / /
.
4. After selecting the character, press .
The selected character appears in the
editing area. (The pointer in the editing
area moves to the right automatically at
this moment.)
5. Repeat the steps above until all charac-
ters are edited.
To enter a blank space in the CAMERA ID
Move the cursor to SPACE and press .
To replace a specific character in the CAMERA ID
1. Move the cursor to the editing area by pressing .
2. Move the pointer to the character to be replaced by pressing or . Then move
the cursor to the character area and select a new character.
3. Press to determine the CAMERA ID.
To erase all characters in the editing area
Move the cursor to RESET and press . All characters in the editing area disappear.
To determine the display position of the CAMERA ID
1. Move the cursor to POSI, and press .
The display shown below appears and
the CAMERA ID is highlighted.
WV-CP460
Highlighted
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE
POSI RET END RESET
................
Character Cursor
Pointer
Character
Area
Command
Editing
Area
CAMERA ID menu
SETTING PROCEDURES