Filter
Top Products
• When “Manual” or “Schedule” is selected when “H.264(1)” or “H.264(2)” is selected for “Recording
format”, even if “Save logs” (®page 74) of “Alarm” is set to “On”, detected alarm logs are not recorded
in the log list.
• When “JPEG” is selected for “Recording format”, “Schedule” is unavailable.
• When “3 mega pixel [4:3]” is selected for “Image capture mode”, “FTP error” is unavailable.
[Overwrite]
Determine whether or not to overwrite when the remaining capacity of the SD memory card becomes
insufficient.
This setting is available only when “Manual” or “Schedule” is selected for “Save trigger”.
• On: Overwrites when the remaining capacity of the SD memory card becomes insufficient. (The oldest
image is the first to be overwritten.)
• Off: Stops saving images on the SD memory card when the SD memory card becomes full.
• Default: Off
Note
• The overwrite setting will be as follows according to the “Save trigger” setting.
• FTP error: Will not be overwritten.
• Alarm input: Will be overwritten.
• Manual, Schedule: Can be determined by selecting “On” or “Off” for “Overwrite”.
JPEG recording
This setting is available only when “JPEG” is selected for “Recording format” of the SD memory card.
[File name]
Enter the file name used for the image to be saved on the SD memory card. The file name will be as follows.
• File name: [“Entered file name” + “Time and date (year/ month/ day/ hour/ minute/ second)”] + “Serial
number”
• Available number of characters: 1 - 8 characters
• Unavailable characters: " & * / : ; < > ? \ |
Note
• When “H.264(1)” or “H.264(2)” is selected for “Recording format”, the name of the saved file will be
given automatically.
• When “FTP error” is selected for “Save trigger”, the file name entered for “File name” on the [FTP img.
trans.] tab of the “Network” page will be used for the file name of the image saved on the SD memory
card.
• When “3 mega pixel [4:3]” is selected for “Image capture mode”, “Pre alarm” cannot be used.
[Image saving interval/Number of images to be saved(Pre alarm)] - [Image saving interval]
When “Alarm input” is selected for “Save trigger”, select a pre alarm interval (frame rate) of saving images on
the SD memory card from the following.
0.1fps/0.2fps/0.33fps/0.5fps/1fps
• Default: 1fps
Note
• When “1920x1080” is selected for the image capture size of the JPEG images to be saved, “1fps”
cannot be selected.
[Image saving interval/Number of images to be saved(Pre alarm)] - [Number of images to be
saved]
Select a number of pre alarm images to be saved on the SD memory card from the following.
60 Operating Instructions
10 Configure the basic settings of the camera [Basic]