Filter
Top Products
6 SmartNode Branch eXchange Quick Start Guide
B.0 Compliance Information
B.1 Compliance
EMC Directive:
• FCC Part 15, Class B
• EN55022, Class B
• EN55024
Low-Voltage Directive (Safety):
• IEC/EN60950-1 2nd Edition
B.2 CE Declaration of Conformity
Patton Electronics, Inc declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2004/108/EC relating to elec-
tromagnetic compatibility, Directive 2006/95/EC relating to electrical equipment
designed for use within certain voltage limits and Directive 2011/65/EU relating to
RoHS compliance. The Declaration of Conformity may be obtained from Patton Elec-
tronics, Inc at www.patton.com/certifications.
The safety advice in the documentation accompanying this device shall be obeyed. The
conformity to the above directive is indicated by CE mark on the device.
B.3 Authorized European Representative
D R M Green, European Compliance Services Limited.
Greyfriars Court, Paradise Square, Oxford, OX1 1BE, UK
B.4 FCC Part 15
This device generates and uses radio frequency energy, and if not installed and used
properly-that is, in strict accordance with the manufacturer’s instructions-may cause
interference to radio and television reception. The device has been tested and found to
comply with the limits for a Class B computing device in accordance with specifications
in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protec-
tion from such interference in a commercial installation. However, there is no guarantee
that interference will not occur in a particular installation. If the device does cause inter-
ference to radio or television reception, which can be determined by disconnecting the
unit, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures: moving the computing equipment away from the receiver, re-orient-
ing the receiving antenna and/or plugging the receiving equipment into a different AC
outlet (such that the computing equipment and receiver are on different branches).