Filter
Top Products
12 C2924M-A (5/05)
Camera Mounting
The CCC1390H Series camera can be mounted from either the top or bottom, depending on the type of camera mount used in your installation. Use
a standard 1/4-20 screw. The maximum thread depth (top) is 0.188 inches (4.7 mm). To extend the thread depth (top) to 0.25 inches (6.4 mm), use
the camera mount spacer (supplied). The maximum thread depth (bottom) is 0.25 inches (6.4 mm).
The CCC1390H Series camera can be fitted with most Pelco lenses and mounted into most Pelco domes and enclosures, resulting in the greatest
possible number of combinations. This means you can find a solution for nearly any application.
When selecting a lens, dome, or enclosure for this camera, consider how the physical dimensions of each component may affect camera
installation and operation. Specifically, you should address the following three issues.
•
Enclosure size:
The camera dimensions are 2.2 (D) x 2.09 (W) x 2.17 (H) inches (5.6 x 5.3 x 5.5 cm). Make sure the enclosure is large
enough for both the camera and the lens.
•
Lens size:
Some lenses have minimum and maximum lengths. To focus the scene correctly, you may have to adjust the lens to its maximum
length. This could affect how it fits within the enclosure.
•
Optical alignment:
The optical center of this camera may be too low for some enclosures. As a result, the lower portion of the scene may
be obstructed by the enclosure itself. The camera sled in many Pelco enclosures has a low side and a high side. You may be able to raise
the optical center by flipping the camera sled to the high side.
NOTE:
To simplify lens and enclosure selection, Pelco offers ImagePak options for the CCC1390H Series camera. Select the lens and the dome or
enclosure. Pelco will build and test it for you. Contact Pelco or your dealer for more information.