Filter
Top Products
14 C2946M-D (6/08)
CONNECTING DC POWER
The C10CH Series camera requires a power supply of 12 VDC ±15% (10.2 to 13.8 VDC). Make sure the power supply has a minimum rating
of 390 mA.
To connect DC power refer to Figure 5, and then complete the following steps:
1. Strip at least 0.4 inches (10 mm) of the insulation from both power wires.
2. Connect the negative wire from the power supply to the indicated hole in the terminal block that is supplied with the camera.
3. Connect the positive wire from the power supply to the indicated hole in the terminal block.
4. Plug the terminal block into the 2-pin connector on the back of the camera and tighten the screw.
5. For safety, add a 1.0 A slow blow fuse to the positive wire from the power supply. The fuse should be less than 4 inches (10 cm) from the
positive terminal on the power supply.
Figure 5. Connecting DC Power
WARNINGS:
• For safety, include a 1.0 A slow blow fuse when connecting DC power, as shown in Figure 5.
• The DC power supply must be UL and CE certified.
• Make sure you wire the power polarity correctly.
POWER
SUPPLY
4 INCHES (10 CM) MAX.
+12 VDC
GND
INPUT