Filter
Top Products
[ 8 ] Pelco Manual C1986M-B (11/03)
POWER AND VIDEO CONNECTIONS
The CC3700 Series camera is designed to operate from a 12 VDC or 24 VAC power supply. The power supply
connections are shown in Figure 4. The LED on the back panel of the camera indicates that power is connected.
Use only a UL Listed Class 2 isolated power supply. Power consumption is less than 6.5 watts.
Figure 4. Power Supply Connections
To connect the camera power and video:
1. Remove the rear cosmetic trim ring from the camera (refer to Figure 1). Thread cabling through the trim ring.
2. Connect the power cable to the two-pin power connector on the back of the camera using the terminal block
connector (provided). Refer to Table A for the recommended wire gauge and wiring distances.
3. Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera. Refer to Table B for
the type of video coaxial cable to use.
4. Reattach the trim ring to the back of the camera.
24 VAC
12 VDC
UL LISTED
CLASS 2
ISOLATED
POWER
SUPPLY
UL LISTED
CLASS 2
ISOLATED
POWER
SUPPLY