Filter
Top Products
16 C2446M-E (11/05)
Label Position
Labels can be placed anywhere on the monitor. This feature allows you to customize the
appearance of your monitor screen.
The following labels are not set at fixed positions:
PRESET LABEL
ZONE LABEL
ZOOM RATIO - XXX.XX
AZIMUTH
1
/ELEVATION
2
- XXX°/-XX°
DIRECTION - NE
ALERT MESSAGE
3
*
TITLE TEXT
To set a label position:
1. Use the joystick to position the cursor beside a label.
2. Press Iris Open.
3. Use the joystick to move the label up, down, left, and/or right.
4. Press Iris Open.
5. Repeat steps 1 through 4 to position other labels.
6. Position the cursor next to Save and Exit. Press Iris Open to save settings and exit
menu.
1
Azimuth is the pan angle from 0° to 359°.
2
Elevation is the tilt position from 0° (horizon) to -90°.
3
The alert message is the warning displayed on the monitor if pressure, temperature, or dew
point inside the dome reach unacceptable levels.
BACK
EXIT
PRESET LABEL 2 (SECS)
ZONE LABEL 2 (SECS)
ZOOM 2 (SECS)
AZIMUTH/ELEVATION 2 (SECS)
DIRECTION OFF
ALARM MESSAGE 2 (SECS)
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP
[ZONE LABEL-------]
[PRESET LABEL-------]
[ALERT MESSAGE-------]
[TITLE TEXT]
SAVE AND EXIT
CANCEL AND EXIT
HELP
XXX°/-XX°
NE
XXX.XX
LABEL POSITION
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
*This setting only applies to
Pressurized Spectra III dome
systems with software version
1.25 or higher.