Filter
Top Products
C3472M-C (9/10) 15
3. Attach the ceiling mount bracket onto the ceiling board (refer Figure 8).
NOTE: Maximum thickness of the ceiling board is 30 mm (1.18 inches) for installation.
Loosen the clamping screws until the length between the clamp plates becomes wider than the thickness of
the ceiling board, and then clamp the ceiling board by tightening the clamping screws. The recommended
tightening torque is 0.61 N·m (6.0 kgf·cm).
Figure 8. Attaching the Ceiling Mount Bracket
4. Connect the video cable and the power cord to the camera (refer to Wiring on page 16).
5. Attach the camera to the ceiling mount bracket using 4 fixing screws (supplied).
ì
Main Body
î
Triangle Mark
ï
Clamp Plates
ñ
Clamping Screws