Pelco MC3710 Security Camera User Manual


 
[ 18 ] Pelco Manual C2913M-F (08/05)
SPECIFICATIONS
GENERAL
Imaging Device: 1/3-inch interline transfer CCD
Picture Elements
MC3710H and MC3610H: EIA 768 (H) x 494 (V); CCIR 752 (H) x 582 (V)
MC3710S: EIA 510 (H) x 492 (V); CCIR 500 (H) x 582 (V)
Sensing Area: 6 mm diagonal
Scanning System
EIA: 525 lines, 2:1 interlace
CCIR: 625 lines, 2:1 interlace
Synchronization System: AC line lock/internal, Genlock (external, MC3710H Series only)
Horizontal Resolution
MC3610H models: 570 TV lines
MC3710S models: 380 TV lines
MC3710H models: 570 TV lines
Iris Control: Selectable on/off
Electronic Shutter Range
EIA: 1/60-1/100,000 second
CCIR: 1/50-1/100,000 second
Auto Iris Lens Type: DC/video drive (automatic sensing)
Minimum Illumination
MC3610H models: 0.04 lux at F1.2, 40 IRE, AGC on
MC3710S models: 0.06 lux at F1.2, 40 IRE, AGC on
MC3710H models: 0.07 lux at F1.2, 40 IRE, AGC on
Signal-to-Noise Ratio: >50 dB
Vertical Phase: Adjustable +180
O
- 110
O
Automatic Gain Control: On/off switchable
Electronic Shutter Control: On/off switchable
Backlight Compensation: On/off switchable
Flickerless Mode: On/off switchable
Internal Sync: On/off switchable
Signal Processing: Analog
Video Output: 1 Vp-p, 75 ohms
Gamma Correction: 0.45
ELECTRICAL
Power Requirements
Low Voltage Models: 24-28 VAC ± 10% or 12-36 VDC ± 10%
High Voltage Models: 110-240 VAC ± 10%
Power Consumption: 4 watts
Power Connector
Low Voltage Models: 2-pin terminal strip, RJ45-10 connector
High Voltage Models: Integral power cable
Video Connector: Composite via BNC, composite and twisted-pair via RJ45-10 (except
MC3710S models)
Service Connector: 2.5 mm jack for optional ICS090-SC service/monitor cable
(compatible with any standard monitor BNC connector)
Lens Jack: 4-pin connector (miniature square)