Pelco SB2800 Security Camera User Manual


 
PELCO Manual C426M-F (2/98)
1
Please thoroughly familiarize yourself with the information in this manual
prior to installation and operation.
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present
within this unit.
CAUTION:
TO REDUCE THE RISK OF ELECTRICAL
SHOCK, DO NOT REMOVE COVER. NO
USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The product bears the following marks:
INSTALLATION/OPERATION MANUAL
MODEL SB3-1/SB3-2 ENCLOSURES
SB2800 SERIES ENCLOSURES
This symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION
This device is designed to operate at 24 volts AC
power. Input voltage must not exceed 28 volts or
drop below 22 volts or else damage to the motors
will occur. Should you need technical assistance,
please call (800)289-9100
1-1.0 WARNINGS
Prior to installation and use of this product, the following
WARNINGS should be observed.
1. Installation and servicing should only be done by
Qualified Service Personnel and conform to all
Local codes.
2. Unless the unit is specifically marked as a NEMA
Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is
designed for indoor use only and it must not be
installed where exposed to rain and moisture.
3. The weight of the camera/lens and enclosure shall
not exceed 20 lbs. — subject to specific pan/tilt
unit.
4. Only use replacement parts recommended by
PELCO.
5. After replacement/repair of this unit’s electrical
components, conduct a resistance measurement
between line and exposed parts to verify the exposed
parts have not been connected to line circuitry.
6. The installation method and materials should be
capable of supporting four times the weight of the
enclosure, pan/tilt, camera and lens combination.