Pentax 15921 Digital Camera User Manual


 
38
1
Getting Started
Precautions When Using an SD Memory Card
The SD Memory Card is equipped with a write-
protect switch. Setting the switch to LOCK
prevents new data from being recorded on the
card, the stored data from being deleted, and
the card from being formatted by the camera or
computer.
r appears on the display when the card is
write-protected.
Care should be taken when removing the SD Memory Card immediately after
using the camera, as the card may be hot.
Keep the card cover closed and do not remove the card or turn the camera off
while the data is being played back or saved to the card, or the camera is
connected to a computer with the USB cable, as this may cause the data to
be lost or the card to be damaged.
Do not bend the SD Memory Card or subject it to violent impact. Keep it away
from water and store away from high temperature.
Do not remove the SD Memory Card during formatting as this may damage
the card and render it unusable.
The data on the SD Memory Card may be deleted in the following
circumstances. We do not accept any liability for data that is deleted
(1) when the SD Memory Card is mishandled by the user.
(2) when the SD Memory Card is exposed to static electricity or electrical
interference.
(3) when the SD Memory Card has not been used for a long time.
(4) when the SD Memory Card is ejected or the battery is removed while the
data on the card is being recorded or accessed.
If it is not used for a long time, the data on the card may become unreadable.
Be sure to regularly make a backup of important data on a computer.
Avoid using or storing the card where it may be exposed to static electricity or
electrical interference.
Avoid using or storing the card in direct sunlight or where it may be exposed
to rapid changes in temperature or to condensation.
When using an SD Memory Card with a slow recording speed, recording may
stop while you are taking movies even when there is adequate space in the
memory, or shooting and playback may take a long time.
Be sure to format SD Memory Cards that are unused or have been used on
another camera. Refer to “Formatting an SD Memory Card” (p.164).
Write-protect
switch