Pentax WG-10 Camcorder User Manual


 
272
9
Appendix
The subject is not
in focus
The subject is difficult to
focus on with autofocus
The camera may have difficulty in
focusing on such subjects as: low
contrast subjects (a white wall, a
blue sky, etc.), dark subjects, finely-
patterned objects, rapidly-moving
objects. It is also difficult to get
proper focus when shooting through
a window or a net (p.67). Try
shooting using the focus lock, or
\ (Manual Focus) (p.111).
The subject is not in the
focusing area
Locate the desired subject in the
focus frame (focusing area) in the
center of the display. If it is difficult to
do so, first lock the focus on the
desired subject (focus lock), and
then move the camera to
recompose.
The flash does not
discharge
The flash mode is set to
a (Flash Off)
Set to , (Auto) or b (Flash On)
(p.108).
The Drive Mode is set to
j (Continuous Shooting),
c (Burst Shooting), or
l (Auto Bracketing);
the Focus Mode is set to
s (Infinity); or the Shooting
Mode is set to d (Movie),
(Underwater Movie),
S (Fireworks) or
(Digital Microscope).
The flash does not discharge in
these modes.
Very occasionally, static electricity may cause camera to malfunction. In
this case, remove the battery and install it again. If the camera is then
working properly, you can continue using the camera.
Problem Cause Remedy