Philips 99F2 Digital Photo Frame User Manual


 
Philips Electronics
-9 -
1.2.6 Play Photos from Memory Card
A B
A. CF Card
B. SD/ MMC /MS / xD Card
Inserting a memory card:
Insert the memory card into the slot in the frame.
For a Compact Flash card, firmly slide card in the larger slot end first and face DOWN.
For a xD, SD, MMC, or Memory Stick card slide card in the smaller slot end first and
face UP until it locks in-place.
After a few seconds photos on the memory card will display and a slideshow will start.
Please DO NOT remove the memory card just after inserting it in PhotoFrame™ or when
PhotoFrame™ is counting the Photo. Wait until the screen is stable
Removing a memory card:
To remove the Compact Flash card, pull out the card slowly.
To remove the xD, xD, SD, MMC, or Memory Stick card, push the card again to unlock
and then pull out the card.
IMPORTANT NOTICE:
Philips PhotoFrame™ do not support memory stick Duo, PRO Duo and
RS-MMC even with adaptor
Note: To copy photo from the memory card to the PhotoFrame™ read the copying photo
section.
Tips: - Increase the memory of the PhotoFrame™ by permanently inserting permanently a
memory card into it.This allows the same functions as the internal memory to be
performed.
- Two memory card slots can be used at the same time; therefore one can be dedicated
for the extended memory, and the other slot for reading and copying pictures from the
camera memory card.
Note: To be able to delete photos on the memory card this function on the memory card must
be allowed. To do so read the “Setup- Memory card” section.