Filter
Top Products
Planar UltraRes Remote Monitoring Software
72 Planar UltraRes User Manual
Monitoring software may not configure to the same network address after the system
reboots.
4
When you click Reset ALL to Factory Default, you receive the Confirm Factory
Reset page. Click OK, Reset to Factory Defaults and Reboot if you are sure you
want to reset ALL settings to the factory default.
5 The top of each page shows the Planar logo, which is a link to
http://www.planar.com. You can change this link to refer to any URL that you find
useful by typing it into the Product ID Link box.
6 To make this link live, click Change Product ID Link.
7 In normal operations, Remote Monitoring polls the displays at a rate of one per
second to look for user requests that have been made using the IR remote control
and the on-screen menus. In some situations, this polling can have a noticeable
performance impact. If you want to disable this polling, select the Disable
polling for alert conditions checkbox. When you are finished, click Change
Advanced Settings.
Reboot
Click Reboot now to reboot your system. The reboot takes about 90 seconds.