Filter
Top Products
7372
CUSTOM FUNCTIONS
The mounted lens must have a focus hold button.
Cust 6 – Focus-hold button (LENS)
1 – Focus Hold
Pressing the focus-hold button on
the lens locks the focus.
2 – Spot Focus
Pressing the focus-hold button on the lens selects the center focus
sensor (p51).
3 – Continuous Focus
Select this setting when focusing on moving subjects.
Pressing the focus-hold button on the lens selects continuous focus.
CUSTOM FUNCTIONS
1 – DX Memory Off
Film speed is always set to the DX-coded ISO. Non-DX-coded film is
set to the ISO of the previous roll.
Cust 4 – DX Memory
2 – DX Memory On
Changes to the film speed for a DX coded roll are saved and applied
to future rolls with the same DX coded ISO. Use to consistently
over/under-expose a specific film type.
• Film must be loaded before the ISO can be changed.
1 – Autoswitchover
Built-in flash pops-up when shutter-release button is pressed partway
down. Flash will fire when necessary.
Cust 5 – Flash Control in P Mode
2 – Fill Flash (Manual Switchover)
Flash-mode button must be pressed to
raise the built-in flash (p26). Flash will fire
every time the shutter is released.
• The TTL exposure system will ensure
correct exposure.
• Push the built-in flash down to select
flash cancel ( ).
2154-E (US).qed 3/4/98 2:43 PM Page 72