Filter
Top Products
48 49
IP200 Manual
authorization selection.
SMTP User. Input correct SMTP user; usually his or her full email address.
Sometimes the address can be inputted without the sufx and just using the
user name.
SMTP Password. Input correct password.
NOTE: Click Submit before going to TEST.
Figure 9.2
If clicking on TEST yields an error, recheck the information your entered to
ensure it was all correct. Then make corrections and click on TEST again. Here
are some possible problems:
1) Cannot connect to server.
2) Network error. Try again later
3). Server error.
4) Incorrect user or password
5) Sender is denied by server. Re-authenticate user and check again.
6) Receiver is denied by server. Anti-Spam privacy software could be blocking.
7) The message is denied by server. Again because of anti-span privacy
software.
8) Server does not support the authentication mode used by the device.
At the bottom of gure 9.1, you will see a box for “Report Internet IP by Mail.”
If you check it, you will receive the camera’s internet IP information via email.
The camera must be on for this information to be transmitted. (For example, the
IPCAM’s URL is http://121.213.109.69:1008)
3.15 Other Settings
Figure 9.0
Using the “other box, you can make settings for Motion Detection, Alarm. IO
Linkage, Schedule, FTP Upload, Alarm Mail Alert, Record Path and more.
3.16 Mail Service Settings
You can set Mail Service Settings to send you an email when motion is detected
in the camera range.
Figure 9.1
Sender. Make sure the senders mail box supports SMTP and does not enable
either SSL or TSL encryptions.
Receivers. You can set up to four receives. There are no SMTP limitations.
SMTP. Senders should have SMTP Server.
SMTP Port. Sender’s SMTP port is usually “25”, but it could have its own
special port number.
Authorization. SMTP needs SMTP user and password input and the then
Polaroid • Settings Polaroid • Settings