Filter
Top Products
16
POLAROID XS100 USER GUIDE
Camera Mounting Methods
The XS100 versatile Mount-Lock Mounting System allows you to use your XS100 in all
types of scenarios. With the included helmet and handlebar mounting systems it allows
you to attach to all types of helmets like bike (vented), motorcycle, ski, skydive, white
water rafting etc. or mount on to a handlebar of a bike, jet ski, 4x4 ATV, Motorcycles as
well as Ski poles. The Mount-Lock system allows you to easily remove and remount the
camera. Visit Polaroidaction.com for additional exciting mounting systems.
Secure string with quick disconnect
to feel more secure, a Secure String is included.
1. Loop one end of the secure strap through the strap hole of the camera. You may use
a pin to help thread it through the hole.
2. Attach the other half to the mount you are using in the strap hole or to any other
secure place.
3. Clip both ends when camera is mounted.
Attaching Mount-Lock to the XS100
1. Fit the screw of the Mount-Lock in to the tripod socket of the camera.
2. Turn the Mount-Lock screw until it is tightened. You can do it by hand using the built-
in triangular wire wrench or with the Mount-Lock key; the Mount-Lock Release Arms
should now be facing the front of the camera.
Installing the Helmet Straps into the Helmet Mount
1. Choose the suitable strap to mount on different types of helmets. For example, use
the short mount strap for bike helmets and the medium mount strap for motorcycle
helmets.
2. Remove the two strap clips from the strap.
3. There are three vents at each side of the Helmet Mount. Loop the strap through the
inner vent (closest to the center) from the bottom. (Step 1)
4. Loop the strap through the strap clip from the top. (Step 2)
5. Loop the strap through middle vent from the top. (Step 3)
6. Loop the strap through the outer vent from the bottom (Step 4)
7. Tighten the strap and repeat Steps 1-4 on the other side.
Mounting Helmet Mount on a Vented Helmet
1. Choose the Helmet Mount with the suitable length of strap.
2. Adhere the single-sided adhesive mount to the base of the helmet mount. Use the
double-sided adhesive mount to permanently secure the mount to the helmet.
3. Loosen and detach the ball joint nut from the helmet mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Mount Socket, and
you should hear a loud click, then tighten the Ball Joint Nut.