Filter
Top Products
17
POLAROID XS100 USER GUIDE
5. Loop the strap of the helmet mount through the vents of the bike helmet and back
through the strap clip.
6. Fasten the strap.
7. Repeat on the opposite end of the strap until the Helmet Mount is firmly attached to
the helmet.
8. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the
Mount- Lock Ball Joint Nut is tightened securely.
9. The ball joint system allows you to change the angle of the camera. Simply loosen
the nut, adjust the camera angle and re-tighten the nut.
Mounting Helmet Mount on a Non-Vented Helmet (motorcycle)
1. Adhere the Helmet Mount to the helmet by applying a double-sided 3M® adhesive
mount. By utilizing a combination of the Helmet Mount and fitting piece with straps;
it will provide additional security to the mounting system.
2. Select the Helmet Mount with a suitable length of strap.
3. Loosen and detach the ball joint nut from the Helmet Mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Helmet Mount
Socket, and you should hear a loud click, then tighten the Ball Joint Nut.
5. Adhere the double-sided adhesive mount to the base of the Helmet Mount and
fitting piece.
6. Attach the Helmet Mount at one side of the helmet.
7. Loop the strap to the other side of the helmet, through the vent of fitting piece, and
back to the original side of the helmet.
8. Fasten the strap with a Strap Clip.
9. Repeat on the opposite end of the strap until the Helmet Mount is firmly attached to
the helmet.
10. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the
Mount-Lock Ball Joint Nut is tightened securely.
11. The ball joint system allows you to change the angle of the camera. Simply loosen
the nut, adjust the camera angle and re-tighten the nut.
Tips for Achieving a Secure Mounting
• When straps are not practical, the 3M® adhesive pads can be used to attach the
mount to smooth surfaces like a motorcycle helmet. And don’t worry about the
adhesive ruining the helmet; they’re removed quite easily when heat is applied (eg.
a hairdryer).
• For best results, maximum adhesion of the adhesive pad is achieved by first
cleaning the helmet surface thoroughly where the pad will be attached. Apply the
pad firmly and allow it to remain unused overnight. The dry time allows the adhesive
to create a stronger bond.
• For ultimate camera support, use the straps and the 3M® adhesive pads.