Filter
Top Products
7
FC-446-021-U.DOC
Set Up 3: 10 mm Diameter Sleeve with a single fiber
Install the 10 mm sleeve to the X-Y adapter and lock it into place by tightening
down the 3 set screws surrounding the adapter. Now gently slide the cable/fiber
into the entrance of the fiber optic input assembly so the end of the fiber adapter
contacts the slits. Now pull the adapter back approximately .1 mm so it is no
longer contacting the slits. Lock the fiber into place by tightening down the set
screw on the 10 mm sleeve. See below.
CAUTION: Never force the fiber optic bundle against the slits or
permanent damage may result.