Filter
Top Products
18
Remote Control
Install Lithium Cell
The remote’s lithium cell is packed separately. Install it as follows:
1. Turn remote over, insert a pencil or
paper clip in small hole and remove
battery holder.
2. Insert battery in battery holder so
positive (+) terminal faces up.
3. Replace battery holder in remote until
it clicks into place.
Back of
Remote Control
Holder
Insert Pencil Here
Lithium Cell
The remote operates the camcorder by infrared light, so it is protected from electrical
and sound interference. However, the remote must be aimed directly at the
camcorder’s remote sensor. There cannot be any obstructions between them.
ZOOM
START/STOP
SELF
INT.
TIME
TIME LAPSE
REC
TIME
ANIM.
PAUSE
FF
A.DUB
INSERT
REW
STOP
PLAY
F
1
2
F
MODE
P
U
S
H
A
U
T
O
M
A
N
scene select
AE
Remote Control Sensor
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace battery when camcorder fails to
respond to remote.
Remove battery from remote if it will not be
used for a month or more. This will prevent
possible damage from battery leakage.
If leakage occurs, wipe up liquid inside
compartment and replace battery.
Note: The camcorder may not respond to the remote if its sensor is exposed to direct
sunlight or strong artificial light.
Remote Sensor
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025.
Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never
handle punctured or leaking cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed,
consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.