Filter
Top Products
55
Recording
Built-In Color Enhancement Light (Continued)
Replace the Bulb Assembly
Carefully follow the instructions below.
Cautions
The video light and bulb need to cool for approximately 30 minutes after
the camcorder has been used before the bulb assembly is replaced.
Do not touch the light bulb with your fingers. If the bulb is accidentally
touched, wipe it with a soft cloth. A dirty bulb may cause smoke and have
a reduced service life.
To Replace the Bulb Assembly
1. Insert a flat nonmetallic object (such
as a plastic screwdriver) in the small
hole as shown.
3. Slide the new bulb assembly into the
camcorder until it is locked into
place.
2. Pull on the sides of the bulb
assembly and remove it from the
camcorder.
Plastic
Screwdriver
Video Light