RCA RP5020 Camcorder User Manual


 
EN
EN
Recording mode
Setting Recording
Mode
You can select between two recording
modes - manual recording and AVR
(automatic voice recording).
1. Manual Recording
1. In STOP mode,
select folder (A/B/C/
D).
2. Press RECORD to
start recording.
(recording time will
be displayed once you
press RECORD)
3. To pause recording,
you can press
RECORD once, press
again to resume
recording.
4. To stop recording, press STOP.
2. AVR (Automatic
Voice Recording)
This feature allows the unit to sense
sound and to record only when you
are speaking into the microphone.
When dictation stops for about 3
seconds, recording will stop and then
start again automatically when you
resume dictation.
1. Select destination folder (1-9).
2. Press MENU four times.
3. Press REVERSE or FORWARD to
toggle between AVR on and AVR off.
4. Press STOP to exit to STOP mode.
5. Press RECORD to enter AVR mode.
6. During AVR on
recording, adjust the
sensitivity of the
microphone by pressing
VOL UP and VOL
DOWN, SEN with
sensitivity value shows
on display (e.g. increase sensitivity
value when recording source is far
from the unit or the recording
envionment is quiet.).
7. Start dictation. Recording starts
automatically.
8. Press STOP to end AVR recording.
9. Repeat step 2 and select AVR OFF
for de-selection.
9
Tip:Tip:
Tip:Tip:
Tip:
To view the remaining time
and other recording
information, you may press
PLAYPLAY
PLAYPLAY
PLAY
during recording.
Tip:Tip:
Tip:Tip:
Tip:
The first syllable or two
may be lost when you start
recording because this
‘sound’ is used to turn on the AVR
feature. It is a good pratice to
make some ‘sounds’ or say a short
word to activate the AVR before
you begin actual dictation.
AVR
AVR
SP
DICT
AVR
AM
A
Bookmark
8
Creating a bookmark
This feature allows you to create an
interception point in the recorded
message for quick reference.
1. During playback, press REC once to
set a bookmark, the bookmark icon
flashes on the display.
2. You can create multiple bookmarks
until the memory is full.
Skipping to a
bookmark
You can skip to a bookmark anytime
during playbcak.
1. During playback, press FORWARD
to go to the bookmark (if available).
2. Press FORWARD again to go to the
next bookmark.
Tip:Tip:
Tip:Tip:
Tip:
When the memory is full,
“FULL” will show on the
display.
Deleting a bookmark
1. Select folder (A/B/C/D)
2. Select file.
3. Press ERASE once and DELETE will
blink on the screen.
4. Press and hold PLAY for 3 seconds to
confirm deleting. (or press STOP to
cancel erasing file)
Tip:Tip:
Tip:Tip:
Tip:
If the file have multiple
bookmarks, steps 1-4 will
delete ALL bookmarks.