Filter
Top Products
3. Battery removal and installation.
A. To remove the battery pack, tilt unit
slightly to slide battery into other hand.
B. To install the battery, Insert contact
end of rechargeable battery pack into
the microEXPLORER inspection cam-
era, as shown in
Figure 3
.
4. Replace battery cover
(Figure 2)
and
snap into place by sliding the lock button
to the middle and releasing to engage the
lock.
Installing the Imager Head
Cable
To use the microEXPLORER inspection cam-
era
,
the imager head cable must be con-
nected to the handheld display unit. To con-
nect the cable to the handheld display unit,
make sure the key and slot
(Figure 4)
are
properly aligned. Once they are aligned, finger
tighten the knurled knob to hold the con-
nection in place.
Figure 4 – Cable Connections
To Install Camera Accessories
The three included accessories, (mirror, hook
and magnet)
(Figure 1)
all attach to the imager
head the same way.
To connect, hold the imager head as shown in
Figure 5
. Slip the semicircle end of the ac-
cessory over the flats of the imager head as
shown in
Figure 5
. Then rotate the accessory
a 1/4 turn so the long arm of the accessory is
extending out as shown
(Figure 6)
.
Figure 5
microEXPLORER
™
DigitalInspection Camera
Ridge Tool Company
6
Figure 6 – Installing Accessories
To install an SD Card
Using the tab on the port cover
(Figure 7)
, lift
and pull to remove the cover and expose the
SD card slot. Insert the SD card into the slot
making sure the contacts are facing towards
you and the angled portion of the card is facing
down. When an SD card is installed, a small
SD card icon will appear in the bottom right
hand portion of the screen, along with the
number of images or length of video that can
be stored on the SD card.
Buttons, Controls and Ports
Figure 7 – Port Cover
Slot
Key
Imaging Head
Accessory
Flats
SD Card
Slot
Mini USB Port
Additional
Accessory
Ports
Expansion
Bay Door
For Other
Accessories
ON/OFF
Button
(Sold Separately)
Port
Cover