Filter
Top Products
18
B W CCD CAMERA
CONNECTION
3. Remove the cover from the connector pin supplied, and
solder the lens cable to the connector pin as shown
below.
• Video type :
No. 1 Pin --- Red (Power source, DC 12V, 40mA MAX)
No. 2 Pin --- N.C
No. 3 Pin --- White (Video signal)
No. 4 Pin --- Black (GND)
• DC type:
No. 1 Pin --- Damping
-
No. 2 Pin --- Damping +
No. 3 Pin --- Drive +
No. 4 Pin --- Drive
-
4. Remove the protecting cap, and attach the lens into the
camera by turning clockwise.
No. 3 Pin
Cover
No. 1 Pin
connector
Lens cable
No. 4 Pin
No. 2 Pin
Lens is not supplied with this camera. Purchase a lens suitable for
your environment. This camera accepts auto iris lens, both C- and
CS-mount lens.
Notes:
If the lens is stained with fingerprint or something, the image quality
might be poor.
It is recommended to use a high quality lens to improve the image
quality under low illumination.
1. Peel the end of lens cable outer cover approximately 8mm. (5/16inch)
2. Peel the end of the cable inner cover approximately 2mm. (1/16inch)
approx.
8 mm(5/16inch)
approx.
2 mm(1/16inch)
19
B W CCD CAMERA