Filter
Top Products
8
ENG
9
❚
Setting switches
Setting function switches
To set the available functions on your camera, adjust eight switches as shown below:
Installation
1. Switch 1 (LL): When this switch is set to
OFF, the camera operates in the internal
synchronization mode, while when it is
set to ON, the camera operates in the
line lock mode.
In the internal synchronization mode, the
camera always uses an inside crystal
oscillator for synchronization. However
if multiple cameras are connected to a
sequential switcher, picture rolling or
flickering may occur when switching from
one camera to another. In this case, you
can set this switch to ON to solve this
problem.
The line lock mode allows the camera
to use the phase of the AC power as
the synchronization reference. In this
mode, you can use the phase control
buttons(INC/DEC).
Note
When you are using the DC 12V power, set
this switch to OFF. The line lock feature will
not normally operate even when the switch is
set to ON.
No Name Brief description
1 LL Line lock ON/OFF
2 LSS Sens-up or Low speed shutter ON/OFF
3 H-REV Horizontal reverse ON/OFF
4 V-REV Vertical reverse ON/OFF
5 BLC Backlight compensation ON/OFF
6 FL Flickerless ON/OFF
7 D/N Automatic switching between color and
black & white ON/OFF
8 AWB Automatic white balance ON/OFF
8
7
6
5
4
3
2
1
INC
DEC
AB68-00688D.indb 9 2007-07-06 ｿﾀﾈﾄ 2:38:42