Filter
Top Products
Connection for power
RJ-45 Connection
7. Pull retractable safety cable
from bottom of camera and
insert into hook, inside upper
housing.
(figure 7a)
1. Remove junction box cover with supplied hex tool to view inner connection block.
(figure 1a)
Inner connection block exposes connections for power, video, alarm input/output as well
as dip switches for selecting camera ID, protocol, baud rate and termination.
(figure 1b)
See
manual for proper settings.
2. Attach wall mount to wall with supplied anchor bolts and make connections.
Inner Box connections
*Note for RS-485 Connection:
GVI uses solid colored wire to represent posi-
tive (+) and striped wire for negative(-) polar-
ity. Regardless of the wire color you choose
make sure polarity matches on both ends of
the connection
Cable connection for dome. Connect
cable from mount into upper housing
Inside view of upper housing
3. Remove camera mechanism from upper housing.
(figure 3a)
4. Use Teflon tape (included) to wrap around pipe fitting.
(figure 4a)
5. Attach safety cable to neck of mount.
(figure 5a)
6. Attach other end of safety cable to housing
(figure 6a)
and now screw in upper
housing to mount pole, bring in cable from pole mount and attach.
(figure 6b)
Safety cable to mount
Teflon tape for tight connection
Safety cable to housing
1a
1b
2a
2b
4a
5a
6a
3a
Retractable safety cable
6b
7a
SCC/SNC-C7478 Installation Guide
SAMSUNG | GVI Security, Inc
.
Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333
www.samsung-security.com
v.11.19.08