Filter
Top Products
SNC-C7478 Setup Guide
SAMSUNG | GVI Security, Inc
.
Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333
www.samsung-security.com
v.11.19.08
IP Setup Guide
36x PTZ IP Dome Camera
SNC-C7478
1. Plug the included cross-over cable into the RJ-45 jack located inside the
inner connection block.
(figure 1a)
2. Plug the other end of the cross-over cable into the RJ-45 jack on back of
your computer.
(figure 2a)
3. From included CD, run the application titled IPInstaller. This will open a
window and scan your computer to locate the default IP address and subnet
mask assigned to the IP dome.
(figure 3a)
4. Once camera has been identified within the window, you may view the default IP settings by first selecting
(clicking) the camera entry in the window, then choosing Manual Set in the lower right of the IPInstaller
window. Make note of the camera IP Address and the Subnet
Mask. You will refer to these in future steps.
(figure 4a)
After
these values have been viewed and written down, you may can-
cel from the Manual Setting window and you may exit the
IPInstaller.
5. Next you will need to set your computer with a static IP address
as well as set your Subnet Mask to the same value as the IP PTZ
Dome Camera. (Subnet Mask value from previous step)
6. From your computer’s Control Panel go to Network and Internet Connections. Enter Network Connections
so that you are able to view all available Network Connections. Your screen should look similar to the
figure below.
(figure 6a)
1a
2a
3a
4a
6a