Filter
Top Products
28_ camera operation
camera operation
EXTERN : Ground to the grounding terminal to allow automatic switching between
COLOR and B/W (Black/White).
COLOR : The picture is always displayed in color.
B/W : The picture is always displayed in black and white.
You can turn on or off the burst signal on B/W mode.
You can use the defog mode to allow the camera to automatically
detect the fog density of the screen and display a clear image despite
smog, fog or general poor visibility.
❶
If the SPECIAL menu screen is displayed, use the Function Setup switch so that
the arrow indicates ‘DEFOG’.
❷
Select a desired mode using the Function Setup switch.
AUTO : Adjust the level automatically.
Manual : Depending on the defog
level set by the user,
adjust the clarity of image.
(LOW, MIDDLE, HIGH)
OFF : Released state
If the defog mode is set to Auto, and if the amount of fog is reduced, the function level will be
also reduced. If you want to maintain the same level of defogging, set it to Manual.
If there is little fog and the manual fog level is high, the screen contrast can get high.
Mask an area you want to hide on the screen.
❶
If the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
‘PRIVACY’.
❷
Select a desired mode using the
Function Setup switch.
AREA : You can select up to 24
PRIVACY areas.
MODE : Determines whether to use the
area selected in the AREA.
MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White, Gray.
TRANSPARENCY : Adds or removes transparency from the masking area.
-
-
-
-
-
-
M
-
-
-
-
DEFOG MANUAL SETUP
▶
1.
LEVEL
MIDDLE
2.
RETURN
PRIVACY AREA SETUP
▶
1.
AREA
AREA1
2.
MODE
OFF
3.
MASK COLOR
GREEN
4.
TRANSPARENCY
OFF
5.
SEL POS
L_TOP
6.
X P
OS
--------
18
7.
Y P
OS
-
-------
33
8.
RETURN