Filter
Top Products
Operating Your Camera
COLOR CCD CAMERA User’s Manual
31
COLOR CCD CAMERA User’s Manual
30
Tips on Using the Motion Detection Feature
• After selecting zone and sensitivity, perform a test operation to make sure it
works properly.
• If the lighting flickers, the motion detection feature might not work properly.
• The object should occupy 10% or more of its zone. The bigger the object, the
higher sensitivity.
• If the brightness of an object changes rapidly by sudden lighting change, the
camera may detect it as a motion.
• When this feature is activated, another algorithm may take more time to be operated.
• This system does not guarantee prevention of fires or thefts. The manufacturer
is not responsible for any accident or damage.
• You can use the MD output terminal jack on the rear of the camera to connect
an external alarm device. For details, see page 40.
Notes
· When completed, press END button.
Lens Selection
You can set the type of the lens, and control the brightness of the screen.
1. Press the SET button to display the setup menu and move the arrow
indicator to 'Lens' using the UP or DOWN button.
2. Set ‘Lens’ to the desired mode using LEFT or RIGHT button.
• You can select from DC / Video, Manual
When using Auto Iris Lens with Video type
Adjust ALC volume on the lens properly. Normally ALC volume should be
turned all the way to Av(Average).
According to the type of the lens used, the lens may not perform properly.
In such a case, adjust the volume level on the lens.
Set AGC / SENS-UP OFF and adjust Lens VR to get proper brightness.
Increase or decrease BRIGHTNESS LEVEL after adjusting Lens VR. If image
brightness doesn’t changes according to BRIGHTNESS LEVEL, adjust Lens
VR again.
DC / Video:When using auto iris lens
SETUP
CAMERA ID OFF
BACKLIGHT WDR
WHITE BAL. ATW
MOTION DET. OFF
LENS DC
SHUTTER ESC
Notes
Manual:When using manual lens