Filter
Top Products
English _13
● OVERVIEW
Rear Side
Item Description
a
Network Port Used to connect a PoE or LAN cable.
b
Lightning protective
grounding port
Used to discharge the lightning current safely outside in order to protect the
camera.
c
Power Port Used to plug the power cable.
d
Alarm Input Port Used to connect the alarm input signal.
e
Video Out Port Analog video output port. (for installation)
f
Reset Button
Resets the camera settings to the default.
Press and hold for about 5 seconds to reboot the system.
J If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
VIDEO
ALARM
IN
ACT LINK
NETWORK
RESET
DC12V
a b c
e df