Filter
Top Products
English _13
OVERVIEW
Changing Remote Control ID
In a multi-DVR system using a single remote control, you can control only the DVR that matches the ID that
you have set using the ID button.
Press the [ID] button to check the ID of each of "REMOCON ID" and "SYSTEM ID".
The defaults are 00 for the System ID and 00 for the Remote ID, respectively.
To change the Remote ID of the IR REMOTE CONTROLLER, press and hold the [ID] button while entering
a desired combination of two digits from 00 to 99.
To change the ID of the DVR, refer to "REMOTE CONTROLLER > REMOTE CONTROLLER ID".
(Page 28)
Press the ID button of the IR REMOTE CONTROLLER to check the ID.
If the system number defined in "REMOTE CONTROLLER" is different from the number specified using the remote
control, no other button than the [ID] buttons will operate.
DIY CAMERA
Equipped with the IR LED and the illumination sensor, enables you to monitor at night as well as in daytime.
You can also use it indoors as well since it is designed for outdoor use.
Part Names
Name Description
a
Camera Fitting
Groove
Groove that is used to fit the camera bracket.
There exist two grooves; one on the top and one on the bottom.
b
IR LED
These are infrared LED's those are controlled by the illumination sensor.
c
Lens
Focal length of 3.8mm enables you to cover relatively longer range of monitoring.
d
Illumination
Sensor
Detects incoming light to control the IR LED.
e
DVR Connection
Cable
Connect the cable directly to the DVR without using a particular power cable.
You can use the mini DIN cable to connect to a remote camera.
1.
2.
3.
4.
M
a
e
b
c
d c
SOC-A100 SOC-A101
Lo-Call 1890 866 900
www.cctvireland.ie