Filter
Top Products
ENGLISH
4545
Setting the Miniket Photo : Setting the System
Setting the NTSC/PAL
You can set the Miniket Photo's output properly when playback on a TV .
1. Turn the Mode Dial to the Settings mode.
2. Press the [POWER] button to turn on the Miniket Photo.
3. Select <NTSC/PAL> by moving the joystick left / right.
4. Select the desired option by moving the joystick up / down and then press
the joystick (OK).
◆ <NTSC>: Sets to NTSC standard.
◆ <PAL>: Sets to PAL standard.
Refer to page 146
5. After you finish setting, turn the Mode Dial to the desired mode.
[ Warning ]
✤
Recording and playback settings should be identical. NTSC recordings are properly played back
in NTSC mode.
✤
If recording and playback settings are different, displayed video may not be perfect.
✤
When using a TV, be sure to set the same output setting. Playback on a TV is not available if the video format is different
than that of Miniket Photo. For example, Miniket Photo is set to PAL and the TV video format is NTSC, then video playback
on the TV is not available.
4
Settings
NTSC/PAL
Move Select
SettingsSettings
NTSC/PALNTSC/PAL
MoveMove SelectSelect
3
SettingsSettings
NTSC/PAL
NTSC/PAL
MoveMove SelectSelect
Settings
NTSC/PAL
Move Select
00934J VP-MS10 UK~053 6/17/06 6:22 PM Page 45