Samsung VP-DC165W(i) Camcorder User Manual


 
24
ENGLISH
Preparation
Maintaining the Battery Pack
Please refer to the Table on page 22 for approximate continuous
recording time.
The recording time is affected by temperature and environmental
conditions.
The recording time shortens dramatically in a cold environment.
The continuous recording times in the operating instructions are
measured using a fully charged Battery Pack at 77 °F (25 ° C).
The remaining battery time may differ from the approximate
continuous recording times given in the instructions.
When replacing the battery pack, only use the same type as is
supplied with this camcorder and is available from your SAMSUNG
retailer.
When the Battery reaches the end of its life, please contact your
local dealer.
The batteries have to be dealt with as chemical waste.
Make sure that the Battery Pack is fully charged before starting to
record.
A brand new Battery Pack is not charged. Before using the Battery
Pack, you need to charge it completely.
Fully discharging a Lithium Ion Battery damages the internal cells.
The Battery Pack may be prone to leakage when fully discharged.
To preserve battery power, keep your DVD Camcorder turned off
when you are not operating it.
If your DVD Camcorder is in Camera Mode, and it is left in STBY
mode without being operated for more than 5 minutes with a
disc inserted, it will automatically turn itself off to protect against
unnecessary battery discharge.
Make sure that the Battery Pack is fitted firmly into place.
Do not drop the Battery Pack. Dropping the Battery Pack may
damage it.
准备
维护电池组
关于连续的摄录时间,请查阅第22页上的图表。
锂电池组大约的记录时间,取决于周围环境的温度。
在寒冷环境中,录制时间会显著缩短。操作说明中的持续录制时间
是在温度为25°C(77°F)时使用完全充满电的电池测量的。由于您
在使用摄录一体机拍摄时,实际的环境温度和条件有可能不相同。
因此实际连续拍摄时间也会不同于表中给出的近似时间。
更换电池时,使用的电池类型必须与本摄像机配套的电池类型相
同,您可以从SAMSUNG零售商购买所需电池。
当你的摄录机锂电池组达到它的使用寿命,请联系当地的售后
服务。
废旧电池组统一集中后进行处理。
请在开始拍摄前,确认电池组已充满电。
全新的锂电池组并没有完全充满电。使用前必须对电池组进行完全
充电。
完全放电会损害锂离子电池组内部的电池单元。
完全放电可能会使锂离子电池组产生泄露 。
为了节省电池电量,请在不操作DVD摄像机时将它关闭。
若您的DVD摄像机设置为“摄像模式”模式,且在插入光盘后处于
“待机”模式和超过5分钟没有操作,它将会自动关闭以防止不必要
的电池放电。
确定锂电池组在稳定的条件下工作。
不要掉落电池组。因为将电池组掉落会损伤电池组。
中 文