Filter
Top Products
SETTINGS AND ADJUSTMENTS
Adjusting the focus
1 Loosen the lens cover fixing screw (A).
2 Turn the cover counterclockwise to align the tab (C) on the
lens cover with the tab (B) on the base and remove the
cover.
3 Remove the hood lens (D), then while watching the image
on the monitor turn the focus ring (E) to adjust the focus.
4 When finished, install the hood lens, then align the tab (C) on
the lens cover with the tab (B) on the base and turn the cover
clockwise until the tab (F) on the cover is aligned with the tab
(B) on the base. Tighten the lens cover fixing screw (A).
TROUBLESHOOTING
Before taking the camera for repairs, please check below to make
sure that the camera is used correctly. If it still does not perform
correctly, please consult your dealer or a Sanyo Authorized Service
Center.
No picture on the monitor screen
• Is the power turned on to all connected devices? Is the voltage
correct?
• Are all the signal connecting cables correctly connected?
• Is the lighting sufficient?
The picture is not clear
• Is the monitor correctly adjusted?
• Is the lens focus correctly adjusted?
• Are the lens surfaces clean?
If there is dust or finger prints on the lens, the image quality will
deteriorate. To clean the lens use a soft cloth or a commercially
available lens cleaning set.
SERVICE:
This camera is a precision instruments and, if treated with care, it
will provide years of satisfactory performance. However, in the
event of a problem, the owner is advised not to attempt to make
repairs or open the cabinet. Servicing should always be referred to
your dealer or Sanyo Authorized Service Center.
E
A
B
C
D
F
C
L73E4/US GB 1998, 20, 15
English 9