Filter
Top Products
CONNECTIONS AND INSTALLATION
Installing the BNC plug (sold separately)
To connect the camera to peripheral devices, use a coaxial cable with BNC plug.
1 Cut the extremity of the coaxial cable (sold separately), as illustrated.
• Cable type RG-6U (5C-2V), 500 m maximum.
If the type of peripheral devices connected, the type of cable used and/or the cable
length are not as specified, the image and synchronization signals may not be
transmitted correctly.
CAUTION:
Use CCTV/Video grade coaxial cable. Due to its construction, an RG-59U cable will not
transmit the signal properly when installed through conduits or through the air, and
therefore cannot be used.
2 Insert the cable through the adaptor, then turn the shielding mesh over.
3 Loosen the center wire securing screw of the plug, then install the cable in the BNC
plug, so that the center wire is threaded through the plug center opening.
Before tightening the center wire securing screw, make sure the center wire comes out
through the plug center opening.
4 Screw the adaptor onto the plug.
7mm 8mm
3 4
1 2
L73E4/US GB 1998, 20, 15
English 7