Filter
Top Products
PREPARATION
Camera installation
A: Lens mount cap
Remove the lens mount cap before
installing the lens (sold separately).
• Use with this camera a CS mount type
auto-iris lens (for 1/3 inch).
Auto-iris lenses regulate the amount of
light entering the camera according to
the brightness of the subject.
• C mount auto-iris lenses can also be used
with the supplied adaptor (see page 7).
B: Installation bracket
The bracket can be fitted at the top or
bottom of the camera. To fix the
bracket, make sure to use the screws
that held the bracket before, and use
the other two screws to seal the
openings on the opposite side.
1 Opening sealing screws (M3x4)
(shorter)
2 Bracket fixing screws (M3x6) (longer)
3 Threaded hole for the support
(1/4"–20 UNC)
• Mounting at the top (R1)
• Mounting at the bottom (R2)
CAUTION:
• When installing the camera support,
select a location that can support the
total weight of the camera and
accessories.
• This installation should be made by
a qualified service person and
should conform to all local codes.
R1 R2
1
2
3
2
2
1
B
A
L53L2/US GB 1995, 11, 1
English 5