Filter
Top Products
Installation of a DC type lens (sold separately)
1/3 inch CS mount type
(Flange-back: 12.5 mm)
1 Remove the lens mount cap.
2 Install the auto-iris lens onto the camera.
Sanyo auto-iris lenses
(sold separately)
• VCL-CS8LY: Standard angle, f= 8 mm
• VCL-CS4LY: Wide angle, f= 4 mm
• VCL-CS2LY: Ultra-wide angle,
f= 2.8 mm
CAUTION:
Do not use a lens if the length “L” is
more than
5 mm. That may damage the
camera and prevent proper installation.
3 Connect the lens plug to the LENS
connector on the side of the camera.
When using lenses from other makers,
make sure that the pins connections in the
plug correspond to the ones of the camera.
Refer to the lens specifications to check the
pins connections in the plug. If they are
different from the ones indicated in the
diagram, remove the original plug and
connect the supplied plug according to the
connections indicated by the diagram.
(For VIDEO type lenses, please refer to
page 7.)
LENS connector layout (A)
1:Brake coil (–) 2:Brake coil (+)
3:Drive coil (+) 4:Drive coil (–)
4 Set the A.I. LENS switch to the DC
position.
The factory default setting is DC.
4
12
3
4
12
3
(A)
1
3
2
4
DC
VIDEO
L
L53L2/US GB 1995, 11, 1
6 English