Filter
Top Products
English
7
MOUNTING THE LENS
4
3
1
2
1
3
2
■
■■
■ Pin layout
■
■■
■ Flange-back adjustment
If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture
will be out of focus (in particular when using auto-iris power zoom lenses, sold separately). If that
is the case, adjust the flange-back position as described below.
1
Using a + screwdriver, loosen the flange-back lock screw (M2:+).
2
Set the zoom lens to the maximum telephoto position, set the focus using the focus ring on
the lens.
3
Set the zoom lens to the maximum wide angle position, set the focus using the flange-back
adjustment dial.
4
Repeat steps 2 and 3, until the image stays in focus when changing from a telephoto shot to
a wide angle shot. When the setting is complete, tighten the flange-back lock screw.
DC type lenses
1 Brake coil (–)
2 Brake coil (+)
3 Drive coil (+)
4 Drive coil (–)
L5AF2_US.book 7 ページ ２００２年１２月２０日 金曜日 午後１時４８分