Filter
Top Products
115 English
EDITING VIDEO CLIPS
4 Specify the start point of the extract.
h Use the procedure below to specify the frame from which the video
clip extract will start.
h Play the video clip until approximately the desired point, pause the
video clip, then play the video clip one frame at a time, stopping at the
start point of the extract. This will be the first frame of the extract.
h If the start point of the video clip is also the start point of the extract,
proceed to step 5.
<Procedure>
Play:
After pausing playback, press and hold the [H] button for about
2 seconds for forward playback, or the [G] button for reverse
playback.
Pause:
During playback, press the SET button.
Accelerated playback:
During playback, press the [G] or [H] button to change the playback
speed.
Single frame:
After pausing playback, press the [H] button to move forward one
frame, or the [G] button to move back one frame.
5 Press the [T/]] button.
h The start point of the video clip
extract is set, and the screen to
specify the end point appears.
h Specify the end point of the
extract by following the same
procedure as in step 4.
<When joining the first and latter
portions>
1 Press the [W/P] button.
h Each time the [W/P] button
is pressed, the sections to
delete and the sections to
save are reversed.
2 Specify the end point of the
extract. The frame following the
end point of the extract will be
the start point of the latter
portion to be joined.
00:00:06
CUT
SAVE
End point
Portion to be deleted
Approximate playback time