Filter
Top Products
Operating Your Camera
COLOR CCD CAMERA User’s Manual
23
COLOR CCD CAMERA User’s Manual
22
5. Select on screen position of the CAM TITLE.
Move the cursor to 'POS' and press SET button.
The CAM TITLE is displayed on the top-left of the monitor screen.
(Default position)
Select the position by using the 4-directional buttons, then press the SET
button to confirm the position.
6. When completed, move the cursor to 'END' and press SET button.
to Locate, then SETto Locate, then SET
FRONT DOOR
to Locate, then SET
FRONT DOOR
White Balance Control
Your camera provides three 'WHITE BAL' control modes for your choosing in
adjusting the white balance.
1. Press the SET button to access the main setup menu and move the indicator
to 'WHITE BAL' using the UP or DOWN button.
2. Set 'WHITE BAL' using the LEFT or RIGHT button.
The three white balance control modes are as follows :
ATW(Auto Tracking White Balance): When color temperature is 1800 ~ 10500˚K,
select this mode.
AWC (Auto White balance Control): The white balance is automatically
adjusted in a specific environment. In order to obtain the best result, press
the SET button while the camera focuses on white paper. If the environment
including the light source is changed, you have to adjust the white balance
again.
Manual: To fine adjust, select the Manual mode. You can increase or decrease
the red or blue factor while monitoring the difference on the screen. Set
to 'MANUAL' mode and press the SET button. Increase or decrease the
value for red(R-Gain) and blue(B-Gain), watching the color of the picture,
and press the SET button when you obtain the best color.