SiPix DV100 Film Camera User Manual


 
4
Inserting the Batteries
The StyleCam DV100 uses two AA alkaline batteries or two AA Ni-MH rechargeable batteries.
Please follow the instructions below to insert the batteries into your StyleCam DV100 camera.
1. Open the battery compartment cover by sliding the door in the direction of the arrow
shown on the cover.
2. Note the battery polarities on the inside of the battery cover and insert two new
batteries.
3. Close the battery cover by sliding it back and clicking it close.
Note:
Do not open the battery cover when the camera’s power is ON.
Please remove the batteries before storing the camera.
Inserting & Removing the Memory Card (SD/MMC)
The StyleCam DV100 uses a Secure Digital or a MultiMedia Card memory card (optional). The
maximum capacity allowed for the memory card is 256MB. Please follow the instructions below to
insert a SD or a MMC card into your StyleCam DV100 camera.
1. Make sure the camera’s power is OFF.
2. Open the battery compartment cover by sliding the door in the direction of the arrow
shown on the cover.
3. Find the memory card slot that is located along the side of the compartment and insert a
SD or MMC card. Insert the card so that the label is facing away from inside the
batteries.
4. Press down on the memory card so that it fits securely inside the slot. Close the battery
cover to start using the camera.
5. To remove the memory card, press down on the memory card with your thumb and the
card will eject. Pull the card out with your fingers and close the battery cover.
Fastening the Hand Strap to the StyleCam DV100
Use the StyleCam DV100 hand strap to give you support when taking a digital video or still image.
Open the Velcro strap and insert one end of the Velcro strap through the strap holder and the
other end of the Velcro strap through the other strap holder. Bring the two ends to the center
where the surface is made of minute hooks and secure the ends of the straps on the minute
hooks by pressing on them. You can adjust the length of the hand strap by adjusting the position
of where you secure the Velcro attachment.