Filter
Top Products
83
Additional information Дополнительная информация
Symptom Cause and/or Corrective Actions
• Slow shutter, low lux or Super NightShot mode is activated.
This is not a malfunction.
• If 10 minutes elapse after you set the POWER switch to
CAMERA or DEMO MODE is set to ON in the menu settings
without a cassette inserted, your camcorder automatically
starts the demonstration.
c Insert a cassette and the demonstration stops.
You can also cancel DEMO MODE. (p. 70)
• NIGHTSHOT is set to ON.
c Set it to OFF. (p. 26)
• NIGHTSHOT is set to ON in a bright place.
c Set it to OFF, or use the NightShot function in a dark place.
(p. 26)
In the playback mode
Symptom Cause and/or Corrective Actions
• The POWER switch is set to CAMERA or OFF (CHARGE).
c Set it to PLAYER. (p. 33)
• The tape has run out.
c Rewind the tape. (p. 33)
• The television’s video channel is not adjusted correctly.
c Adjust it. (p. 30)
• EDIT is set to ON in the menu settings.
c Set it to OFF. (p. 66)
• The video head may be dirty.
c Clean the heads using the Sony V8-25CLD cleaning cassette
(not supplied). (p. 94)
• The stereo tape is played back with HiFi SOUND set to 2 in the
menu settings.
c Set it to STEREO. (p. 66)
In the recording and playback modes
Symptom Cause and/or Corrective Actions
• The battery pack is not installed, or is dead or nearly dead.
c Install a charged battery pack. (p. 13, 14)
• The AC power adaptor is not connected to the mains.
c Connect the AC power adaptor to the mains. (p. 19)
• The operating temperature is too low.
• The battery pack is not fully charged.
c Charge the battery pack again. (p. 14)
• The battery pack is completely dead, and cannot be recharged.
c Replace with a new battery pack. (p. 13)
(Continued on the following page)
Troubleshooting
An unknown picture is displayed in
the viewfinder.
Some tiny white spots appear in the
viewfinder. (CCD-TR918E only)
Picture appears too bright, and the
subject does not appear in the
viewfinder.
The picture is recorded in incorrect
or unnatural colours.
The tape does not move when a
video control button is pressed.
The playback picture is not clear or
does not appear.
The power does not turn on.
No sound or only a low sound is
heard when viewing the recording
on TV. (CCD-TR918E only)
The battery pack is quickly
discharged.