Sony CMR-PC2 USB Digital Camera User Manual


 
15
Removing the Mount
Turn the stands rotation knob counterclockwise to loosen the suction
mount, and then lift one edge of the suction mount to peel it away from
the mounting surface.
Removing the Camera from the Stand
Remove the camera from its stand as shown in the illustration below.
Detaching the Camera
Note
If you detach your camera while the computer is powered on, be sure to perform the
following procedures. If this is not performed correctly, there is a risk that the
computer may fail to operate correctly.
When you detach the camera while the computer power is off, step 1 is not required.
However, when the USB cable is disconnected with the computer in the power saving
mode, the system may not recognise the camera if the USB cable is plugged in again.
1 Close the software used with your camera.
2 Unplug the USB cable.
Note
Unplugging by grasping a part of the cable may result in damage.
Be sure to hold the connector section when unplugging.
When using the camera monitor mount with the CMR-PC2 USB or the CMR-PC3
USB, pull the arm plate open with your fingers and remove the camera from the
camera monitor mount.
Suction mount
Camera
Rotation knob
Stand