Filter
Top Products
28 (GB) Chapter 2 Operation
Chapter 2
D-SUB SYNC
Switches the sync signal output from the RGB/SYNC
connector (D-sub 9-pin) at the rear panel.
RGB SYNC
Adds a sync signal to the G signal or R, G and B signals
output from the RGB/SYNC connector.
Selection
C.SYNC
WEN
Function
Outputs the composite sync signal.
Outputs the WEN signal. When connecting peripheral
equipment, the signal is used as trigger pulse output to
the equipment.
Select the polarity of the WEN signal with the
POLARITY setting.
: Negative
: Positive
Selection
OFF
G
RGB
Function
No sync signal is added to an output signal.
Adds a sync signal to the G signal output from the
RGB/SYNC connector.
Adds sync signals added to the G, B and R signals
output from the RGB/SYNC connector.
Adjusting and Setting with Menus
Setting item
(VBS lock)
H. PHASE*
SC. PHASE ROUGH*
SC. PHASE FINE*
(HD/VD lock)
H. PHASE*
Contents of setting
Adjusts the horizontal phase and
SC (subcarrier) phase during
external synchronization (with
VBS signal input).
Adjusts the horizontal phase
during external synchronization
(with HD/VD signal input).
Ref. page
29
30
* Displayed only when an external sync signal is input.
BAUD RATE
Switches the baud rate of the REMOTE connector at the
rear panel.
Sets to any of 19200, 9600, 4800, 2400 and 1200.
Normally, set to 9600 when the RM-C950 remote control
unit is connected to the REMOTE connector.
D-SUB VIDEO
Switches the video signal output from the RGB/SYNC
connector (D-sub 9-pin) at the rear panel.
Selection
VBS
Y/C
Function
Outputs VBS signal.
Outputs Y/C signal.