Filter
Top Products
Chapter 2 Operation 27
(GB)
Chapter 2
TRIGGER
Set when you use a slave unit connected to the TRIG IN
connector and synchronize the camera with a stroboscope.
NEGA
Reverses the output image to negative/positive.
FLICKER CANCELLER
When using the camera in a 50 Hz lighting area (DXC-390)
or in a 60 Hz lighting area (DXC-390P), you can obtain
images with less flicker under fluorescent light even when
SHUTTER is set to CCD IRIS or OFF. Set this item to OFF
when you want to set NEGA to ON.
Selection
OFF
ON
Function
Select when you do not connect a slave unit.
Select when you connect a slave unit.
Select POLARITY, and set it to the same polarity as
the input pulse signal.
: Falling edge
: Rising edge
Selection
OFF
ON
Function
Outputs the image normally.
Outputs the image reversed to negative/positive.
Selection
OFF
ON
Function
Disables the FLICKER CANCELLER function.
Reduces flicker.
SYSTEM menu
Sets the items relating to the system of the camera and
selection of output signals.
Setting items in the SYSTEM menu
Setting item
BAUD RATE
D-SUB VIDEO
D-SUB SYNC
RGB SYNC
12P
CONNECTOR
Contents of setting
Selects the baud rate.
Switches the video signal output from
the RGB/SYNC connector (D-
sub 9-pin).
Switches the sync signal output from
the RGB/SYNC connector (D-
sub 9-pin).
Adds a sync signal to the RGB output.
Switches the input and output of the
DC IN/VBS connector and
selects the output signal.
Ref. page
28
28
28
28
29
<SYSTEM>
>BAUD RATE
D-SUB VIDEO
D-SUB SYNC
RGB SYNC
12P CONNECTOR
[A]
9600
VBS
C.SYNC
G
IN
Select Back
MENU
(Continued)