Filter
Top Products
41
Applications
5 Make sure that the built-in flash and flash are fully
charged.
• is lit in the viewfinder when the built-in flash is fully charged.
• The AF illuminator on the front blinks, and on the rear is lit, when
the flash is fully charged.
6 Use test flash to check the flash.
• The test flash method differs depending on the camera used. For
details, see the operation instructions of your camera.
• If the test flash does not work, change the position of the camera,
flash and subject, or point the wireless control-signal receiver
towards the camera.
7 Check again that the built-in flash and the flash are
fully charged, and press the shutter button to take the
photo.
• Do not take photos when RATIO is displayed on the data panel. The
exposure may not be correct.
Continued on the next page